Sensor, Wheel Speed, Front: Installation
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - WHEEL SPEED SENSOR MOUNTING BOLT |
| 2 - WHEEL SPEED SENSOR |
| 3 - HUB/BEARING |
NOTE:
Do not reuse wiring harness routing clips, they must be replaced if removed from the mounting holes.
- Install the wiring to the clips and connect the electrical connector.
- Install the wheel speed sensor (2) to the hub (3).
- Install the wheel speed sensor mounting bolt (1) to the hub (3) and tighten to 13 N.m (115 in. lbs.).
- Install the front rotor and brake caliper assembly. Refer to ROTOR, BRAKE, INSTALLATION and INSTALLATION .