6.7L Diesel Engine
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - O-RING SEAL |
| 2 - GROOVE |
| 3 - WATER PUMP |
- Install new O-ring seal (1) in groove (2) on water pump (3).
1 - BOLT 2 - WATER PUMP - Install water pump (2) with the weep hole facing downward. Tighten mounting bolts (1) to 24 N.m (18 ft. lbs.) torque.
- Install generator assembly. Refer to GENERATOR, Installation .
- Install accessory drive belt. Refer to BELT, Serpentine, Installation .
- Install air box and tube assembly. Refer to BODY, Air Cleaner, Installation, 6.7L .
- Install air filter housing. Refer to BODY, Air Cleaner, Installation, 6.7L .
- Evacuate air and refill cooling system. Refer to PUMP, Water, Standard Procedure .
- Connect both battery cables.
- Start and warm the engine. Check for leaks. Refer to Diagnosis and Testing .