Module, Heated Seat (HSM): Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

When equipped with a leather wrapped heated steering wheel and replacement of a Heated Seat Module (HSM) is required, the new HSM must be manually configured with a scan tool. Failure to follow these instruction may result in damage to the heated steering wheel.

Courtesy of CHRYSLER GROUP, LLC

Install the Heated Seat Module (HSM) (4) to the seat frame (2). Position the two rear retaining tabs (3) into the slots in the seat frame, then push the HSM upward until the lock tab (1) engages the seat frame.

Courtesy of CHRYSLER GROUP, LLC
Connect the electrical connectors (1) to the HSM.
Reconnect the negative battery cable.
When equipped with leather wrapped heated steering wheel, use the diagnostic scan tool and configure the HSM.