LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1592 (Electronic Control Modules - (Service Information) - 2500 Hd) >> Module, Body Control (BCM) >> Removal

Module, Body Control (BCM): Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0154501Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Remove the remote park release access panel.
  3. Remove the left sill and cowl panel. Refer to PANEL, COWL TRIM, REMOVAL .
  4. Remove the amplifier. Refer to AMPLIFIER, REMOVAL .
  5. Remove the park brake release rod at the park brake, remove lever and rod Refer to PEDAL, PARKING BRAKE, REMOVAL .
  6. Disconnect the park brake switch harness connector.
  7. Position the park brake assembly aside (3 nuts)
  8. Disconnect the harness connectors (5) and retainers at the BCM (2).
    GC0154493Courtesy of CHRYSLER GROUP, LLC
  9. Remove the two lower and two upper BCM bolts (3) to remove the BCM (2) from the bracket.
scientia non olet · About LEMON Manuals