LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1592 (Electronic Control Modules - (Service Information) - 2500 Hd) >> Module, Anti-Lock Brake System (Abs) >> Removal

Module, Anti-Lock Brake System (Abs): Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

When removing ABM from HCU, be sure to completely separate the two components (approximately 38 mm (1.5 in.) before removing ABM. Otherwise, damage to the pressure sensor or Pump Motor connection may result requiring HCU replacement. Do not to touch the sensor terminals on the HCU side or the contact pads on the ABM side as this may result in contamination and issues in the future.

  1. Remove the negative battery cable from the battery.
  2. Pull up on the ABM harness connector release and remove connector.
  3. Remove the ABM mounting bolts.
  4. Remove the pump connector from the ABM.
  5. Remove the ABM from the HCU.
scientia non olet · About LEMON Manuals