LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1592 (Electronic Control Modules - (Service Information) - 2500 Hd) >> Module, Ammonia Sensor >> Removal >> Removal

Module, Ammonia Sensor: Removal: Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0155143Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate both negative battery cables.
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  3. Disconnect the ammonia sensor module wire harness connector (3).
  4. Disconnect the ammonia sensor wire harness connector (4)
  5. Remove the nuts (1) and the ammonia sensor module (2).
scientia non olet · About LEMON Manuals