Sensor, Exhaust Pressure: Removal
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate both negative battery cable.
- Remove the oil dip stick (2).
- Remove the bolts (1) and the engine cover (3).
- Remove the exhaust pressure sensor wire harness connector (1).
- Remove the exhaust pressure sensor (1).
- If required, remove bolt (2) securing the exhaust pressure sensor tube (1) to EGR cooler bracket.
- If required, remove fitting (3) and the exhaust pressure sensor tube (1).