Sensor, Differential Pressure: Removal
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate both of the negative battery cables.
- Raise and support vehicle. Refer to HOISTING, STANDARD PROCEDURE .
- Disconnect the Differential Pressure Sensor (DPS) wire harness connector (2).
- Disconnect the DPS hoses (4).
- Remove the nuts (1) and the DPS sensor (3).
- If necessary, remove the bolts (2, 5) securing the differential pressure tubing.
- If necessary, remove the fittings (1, 6) and the differential pressure tubing.