NOX Sensor 1/2
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate both of the negative battery cables.
 Courtesy of CHRYSLER GROUP, LLC
|
- Disconnect the NOx sensor module wire harness connector (1).
- Remove nuts (2) and the NOx module (3).
 Courtesy of CHRYSLER GROUP, LLC
|
- Disconnect the wire harness retainers.
- Remove the NOx sensor 1/2 (1) from the Selective Catalytic Reduction (SCR) catalyst (2).