Cover, Oil Pump: Installation
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
To avoid contamination and garter spring dislodgement, do not handle the front cover seal (4) when positioning the front cover into the transmission case.
- Position a new front cover (1) into the transmission case.
- Using the front cover installation tool (special tool #9955, Installer, Front Cover) (1) and a dead-blow mallet, install the front cover into transmission case.
- Install the snap ring (3) into the transmission case.
- Apply RTV silicone to the oil pan and install the transmission oil pan.
- Tighten the bolts to 12 N.m (105 in. lbs.).