Actuator, RECIRCULATION Door: Removal
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.
- Remove the instrument panel assembly. Refer to PANEL, INSTRUMENT, REMOVAL .
- Remove the two screws (2) that secure the recirculation door actuator (3) to the air inlet housing and remove the actuator.