Sensor, Crankshaft Position: Installation
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
 Courtesy of CHRYSLER GROUP, LLC
|
- Install the Crankshaft Position (CKP) sensor (1). Tighten bolt (2) to 10 N.m (89 in. lbs.).
 Courtesy of CHRYSLER GROUP, LLC
|
- Connect the CKP sensor wire harness connector (1).
- Remove support and lower the vehicle.
- Connect both of the negative battery cables.