LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1576 (6.7L Engine (Service Information) - 2500 Hd) >> Valve Timing >> Housing, Timing Case, Front >> Installation

Housing, Timing Case, Front: Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0155250Courtesy of CHRYSLER GROUP, LLC
  1. Inspect oil pan gasket. If torn, gasket must be replaced.
  2. Install a new front timing case housing gasket (4).
  3. Place a small amount of Mopar® engine RTV to the corners of the block and pan gasket T-joint to ensure a good seal.
  4. Install the front timing case housing (3) and tighten bolts (1, 3) finger tight.
    Fig 1: Gear Housing Bolt Tightening Sequence
    GC0108631Courtesy of CHRYSLER GROUP, LLC
  5. Using the tightening sequence shown in illustration, tighten bolts to 24 N.m (18 ft. lbs.).
    GC0155254Courtesy of CHRYSLER GROUP, LLC
  6. Install the front six oil pan bolts (1) and tighten to 43 N.m (32 ft. lbs.).
  7. Install Crankshaft Position (CKP) sensor. Refer to SENSOR, CRANKSHAFT POSITION, INSTALLATION .
  8. Install the fuel injection pump. Refer to PUMP, FUEL INJECTION, INSTALLATION .
  9. Install the power steering pump. Refer to PUMP, INSTALLATION .
  10. Install the camshaft. Refer to INSTALLATION .
  11. Connect both of the negative battery cables.
  12. Start engine and inspect for leaks.
scientia non olet · About LEMON Manuals