Sensor, Turbocharger Speed: Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect and isolate both of the negative battery cables.
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Remove the right wheelhouse splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE .

Courtesy of CHRYSLER GROUP, LLC
Disconnect the speed sensor wire harness connector (1).

Courtesy of CHRYSLER GROUP, LLC
Cut the cable tie (2) securing the speed sensor wire harness to the turbocharger speed sensor wire harness.
Open the clip (1) securing NOx wire harness and the turbocharger speed sensor wire harness.
Remove support and lower the vehicle.

Courtesy of CHRYSLER GROUP, LLC
Remove the bolt (2) and separate the retainer clip securing NOx wire harness and the turbocharger speed sensor wire harness to turbocharger actuator.

Courtesy of CHRYSLER GROUP, LLC
Remove the banjo bolt and the turbocharger coolant line.
CAUTION:
Do not use a screw driver or tool to pry sensor out of the turbocharger bearing housing. Damage to sensor may result. If sensor is damaged during removal, install a new sensor.
Remove the bolt (2) and the turbocharger speed sensor (1).
Remove the old O-ring and clean out the bore, being careful not to drop any debris in the hole.