LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1576 (6.7L Engine (Service Information) - 2500 Hd) >> Turbocharger System >> Lines, Tubes And Hoses, Turbocharger, Oil And Coolant >> Removal

Lines, Tubes And Hoses, Turbocharger, Oil And Coolant: Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0157540Courtesy of CHRYSLER GROUP, LLC
  1. Remove the RH engine mount. Refer to INSULATOR, ENGINE MOUNT, FRONT, REMOVAL, 6.7L  or INSULATOR, ENGINE MOUNT, REAR, REMOVAL, 6.7L .
  2. Drain the cooling system. Refer to STANDARD PROCEDURE .
  3. Remove the bolts (1) and the turbocharger oil drain tube (5) from the turbocharger.
  4. Remove the banjo bolt (4) and the turbocharger coolant tube (3) from the turbocharger.
    GC0157541Courtesy of CHRYSLER GROUP, LLC
  5. Cut the cable tie (6) securing the NOx sensor wire to coolant tube (2).
  6. Remove the coolant tube (2) banjo bolt (7) from turbocharger.
  7. Remove the union nut (3) and the coolant tube (2).
  8. Remove the turbocharger oil supply line (5) union nut (4).
  9. Remove the union nut (1) and the oil supply line (5).
scientia non olet · About LEMON Manuals