LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1576 (6.7L Engine (Service Information) - 2500 Hd) >> Engine Block >> Seal, Crankshaft Oil, Rear >> Removal

Seal, Crankshaft Oil, Rear: Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate both of the negative battery cables.
  2. On automatic transmission vehicles, remove the flexplate. Refer to FLEXPLATE, REMOVAL, 6.7L .
  3. On Manual transmission vehicles, remove the flywheel. Refer to FLYWHEEL, REMOVAL .
    GC0108571Courtesy of CHRYSLER GROUP, LLC
  4. Using a 3/32 (0.0938 in.) drill bit, drill two pilot holes 180° apart into the rear seal (2). Use caution not to contact the crankshaft (3) or the seal retainer when drilling pilot holes.
  5. Install a No. 10 sheet metal screws (1) in the drilled pilot holes and remove the rear crankshaft oil seal (3) with a slide hammer (4).
scientia non olet · About LEMON Manuals