LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1576 (6.7L Engine (Service Information) - 2500 Hd) >> Engine Block >> Damper, Vibration >> Installation >> High Output Engine

High Output Engine

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0155215Courtesy of CHRYSLER GROUP, LLC
NOTE:

The transmission adapter cover (2) is located on the right side of the converter housing.

  1. Remove the transmission adapter cover bolt (1) and loosen the other bolt (3). Rotate the cover (2) to gain access for the barring tool to be installed.
  2. Install the Barring Tool (special tool #7471B, Barring Tool) with breaker bar.
    GC0143939Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    If the damper has not been replaced and is only being reinstalled, the barring adapter (3) must be reinstalled with NEW  bolts (1).

  3. Ensure that the friction shim (5) is installed, and that the damper is installed so the hole is located over the dowel pin (2).
  4. Using NEW  bolts (1), install the friction shim (5) and the vibration damper (4). While holding the breaker bar to prevent the engine from turning, tighten bolts to 40 N.m (30 ft. lbs.) plus an additional 60° in a criss-cross pattern.
  5. Remove the Barring Tool (special tool #7471B, Barring Tool)

    .

    GC0155215Courtesy of CHRYSLER GROUP, LLC
  6. Install the transmission adapter cover (2) and tighten the bolts (1, 3) to 10 N.m (89 in. lbs.).
  7. Install the accessory drive belt. Refer to BELT, SERPENTINE, INSTALLATION .
scientia non olet · About LEMON Manuals