LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1576 (6.7L Engine (Service Information) - 2500 Hd) >> Cylinder Head >> Valves, Intake And Exhaust >> Installation

Valves, Intake And Exhaust: Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the NEW  valve seals. The yellow seals are for the intake valves and the green seals are for the exhaust valves.
    GC0108527Courtesy of CHRYSLER GROUP, LLC
  2. Install the valves (1, 2) in their original position. The exhaust valves (2) are identified by a dimple on the valve head.
    GC0108520Courtesy of CHRYSLER GROUP, LLC
  3. Install the valve springs (4), and retainer (5).
    GC0108518Courtesy of CHRYSLER GROUP, LLC
  4. Install the Valve Spring Compressor Tool base (special tool #8319, Compressor, Valve Spring) (1) as shown in illustration.
    GC0108519Courtesy of CHRYSLER GROUP, LLC
  5. Install the Valve Spring Compressor top plate (1), washer, and nut (special tool #8319, Compressor, Valve Spring).
  6. Compress the valve springs and install the valve retaining locks.
  7. Remove the Valve Spring Compressor tool (special tool #8319, Compressor, Valve Spring) and repeat the procedure on the remaining cylinders.
  8. Install the cylinder head. Refer to INSTALLATION .
scientia non olet · About LEMON Manuals