LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1576 (6.7L Engine (Service Information) - 2500 Hd) >> Cylinder Head >> Cover(S), Cylinder Head >> Removal >> Cylinder Head Cover

Cylinder Head Cover

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0161582Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate both negative battery cables.
  2. Remove the engine oil dipstick (2).
  3. Remove the bolts (1) and the engine cover (3).
    GC0110278Courtesy of CHRYSLER GROUP, LLC
  4. Disconnect the crankcase pressure sensor 1 wire harness connector (7).
    GC0155113Courtesy of CHRYSLER GROUP, LLC
  5. Disconnect the crankcase pressure sensor 2 wire harness connector (1).
    GC0108506Courtesy of CHRYSLER GROUP, LLC
  6. Remove the Closed Crankcase Ventilation (CCV) cover and crankcase breather. Refer to SYSTEM, CLOSED CRANKCASE VENTILATION (CCV), REMOVAL .
  7. Remove the two CCV drains tubes (3) from cylinder head cover.
    GC0155280Courtesy of CHRYSLER GROUP, LLC
  8. Remove the bolts (1) and the cylinder head cover (2).
    GC0155340Courtesy of CHRYSLER GROUP, LLC
  9. If necessary, disconnect both of the fuel injector wire harness connectors (1).
    GC0108507Courtesy of CHRYSLER GROUP, LLC
  10. If necessary, loosen the fuel injector wire harness nuts (1) on the cylinder head cover gasket (2).
  11. If necessary, remove the cylinder head cover gasket (2).
scientia non olet · About LEMON Manuals