LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1567 (Tires & Wheels - (Service Information) - 2500 Hd) >> Wheels >> Stud, Wheel >> Removal >> Front

Stud, Wheel: Removal: Front

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0083092Courtesy of CHRYSLER GROUP, LLC
  1. Raise and support the vehicle.
  2. Remove the wheel and tire assembly.
  3. Remove the brake caliper, caliper adapter and rotor. Refer to ROTOR, BRAKE, REMOVAL .
  4. Remove the wheel speed sensor from the hub.
    NOTE:

    After the wheel stud is pressed from the flange, the axle shaft will not turn past the hub/bearing retaining bolt end. Before pressing the wheel stud from the flange, rotate the axle shaft so the stud that needs replacement is aligned with the wheel speed sensor opening.

  5. Press the stud from the hub using remover (special tool #C-4150A, Press, Ball Joint) (1).
    GC0083093Courtesy of CHRYSLER GROUP, LLC
  6. Remove the stud (2) from the hub (1) through the backing plate access hole (3).
scientia non olet · About LEMON Manuals