Connector, Trailer Tow: Installation
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Insert the trailer tow connector (3) into the mounting hole of the rear bumper with the 7-pin connector oriented toward the bottom of the bumper.
- Using hand pressure, press the connector firmly and evenly into the bumper until both spring clips (1) on the connector housing snap into place on the back side of the bumper (2).
- Reach behind the bumper (2) to access and reconnect the connector (1) of the body wire harness to the connector receptacle on the back of the trailer tow connector housing (3).
- Reconnect the battery negative cable.