Solenoid, Winch: Installation
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Solenoid #4 shown in the illustration, all others similar.
- Slide the solenoid (1) into the retaining tab (2).
- Install the control wires (2) and install the nuts (1).
- Tighten the nuts to 3 N.m (25 in. lbs.).
- Install the bus straps (4) and connect the cables.
- Install the nuts (2 and 3) and tighten to 9.5 N.m (85 in. lbs.).
- Install the control unit (1). Refer to CONTROL UNIT, WINCH, INSTALLATION .