Erasing HOMELINK® Transceiver Codes (Electronic Vehicle Information Center (EVIC) Equipped Vehicles.

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

To erase programming from all three buttons (individual buttons cannot be erased but can be "reprogrammed"), follow the step noted:

Press and hold the two outer HomeLink® transceiver buttons until the EVIC displays "CLEARING CHANNELS", do not release the buttons until "CHANNELS CLEARED" is displayed on the EVIC (after approximately 20 seconds). Release both buttons. Do not hold for longer that 30 seconds. HomeLink® is now in the train (or learning) mode and can be programmed at any time beginning with "Programming". Refer to STANDARD PROCEDURE .