Diagnostic Test

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

TEST RADIO
1. With the scan tool, record the DTC's.
2. Erase the DTC's.
3. Turn the ignition off.
4. Turn the ignition on and the radio in Satellite mode.
5. With the scan tool, erase the DTC's again.
6. Put the satellite radio in seek up mode for two loops around the band cycle.
7. With the scan tool, read the active DTC's.
  Does the scan display: B1430-Satellite Radio Antenna Internal Performance as Active?
  
  Yes
  - Replace the Satellite Radio in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and poor fit.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .