LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 142 (Audio (Radio) - Electrical Diagnostics) >> DTC Troubleshooting >> B142E-GPS Antenna Not Connected >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. TEST ANTENNA 
    1. Turn the ignition off.
    2. Disconnect the GPS Antenna connector.
    3. Inspect the GPS Antenna connection.

      Was the Antenna connection clean and secure?

      Yes 

      • Go To  2.

      No 

      • Repair the Antenna connection as needed.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  2. ANTENNA 
    1. Refer to the Audio System in the service information and test the Antenna in accordance with the service procedure.

      Is the Antenna OK?

      Yes 

      • Go To  3.

      No 

      • Repair or replace the Antenna assembly as necessary.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  3. RADIO 
    NOTE:

    Reconnect all previously disconnected components.

    NOTE:

    Move vehicle outside approximately 9.14 m (30 ft.) from any structure.

    1. Turn the ignition and Radio on.
    2. With the scan tool, erase the audio DTC's and operate the navigation system.
    3. With the scan tool, read the audio DTC's.

      Did this DTC reset?

      Yes 

      • Replace the Radio in accordance with the Service Information.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

      No 

      • Test Complete.