LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 136 (Emissions Control) >> Exhaust Gas RECIRCULATION Valve, 6.7L Diesel >> Tube, Exhaust Gas RECIRCULATION (EGR), Crossover >> Removal >> Pick Up Models

Pick Up Models

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: EGR Crossover Tube Cover
GC0108069Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate both negative battery cables at batteries.
  2. Remove bolts (1) and the EGR crossover tube cover (2).
    Fig 2: EGR Crossover Tube, Clamps & Connector
    GC0137182Courtesy of CHRYSLER GROUP, LLC
  3. Loosen and remove two clamps (1 and 3) at ends of EGR Crossover Tube (2).
  4. Disconnect the EGR temperature sensor harness connector (4).
  5. Remove clamp mounting bolt (5) at center bottom of EGR crossover tube.
  6. Remove EGR crossover tube (2).
  7. Remove and discard gaskets at each end of tube (2).
scientia non olet · About LEMON Manuals