LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (6.7L Engine (Service Information)) >> Lubrication >> Switch, Oil Pressure >> Installation >> Installation

Switch, Oil Pressure: Installation: Installation

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

  1. Using a new O-ring, install the oil pressure switch. Tighten to 18 N.m (159 in. lbs.).
  2. Connect oil pressure switch harness connector.
  3. Connect the battery negative cables.
  4. Start engine and check for oil leaks at the switch.
scientia non olet · About LEMON Manuals