LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (6.7L Engine (Service Information)) >> Lubrication >> Pump, Engine Oil >> Removal >> Removal

Pump, Engine Oil: Removal: Removal

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Oil Pump & Bolts
GC0108598Courtesy of CHRYSLER GROUP, LLC
1 - OIL PUMP
2 - BOLT (4)
  1. Disconnect the battery negative cables.
  2. Remove fan/drive assembly. Refer to FAN, COOLING, ELECTRIC, REMOVAL and FAN, COOLING, VISCOUS, REMOVAL .
  3. Remove the accessory drive belt. Refer to BELT, SERPENTINE, REMOVAL .
  4. Remove the fan support/hub assembly.
  5. Remove crankshaft damper. Refer to DAMPER, VIBRATION, REMOVAL, 6.7L .
  6. Remove power steering pump.
  7. Remove accessory drive belt tensioner.
  8. Remove the gear housing cover. Refer to COVER(S), ENGINE TIMING, REMOVAL, 6.7L .
  9. Remove the four mounting bolts (2) and pull the oil pump (1) from the bore in the cylinder block.
scientia non olet · About LEMON Manuals