LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (6.7L Engine (Service Information)) >> Engine Block >> Retainer, Crankshaft Rear Oil Seal >> Removal >> Removal

Retainer, Crankshaft Rear Oil Seal: Removal: Removal

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Crankshaft Rear Seal Retainer, Gasket & Bolts
GC0108553Courtesy of CHRYSLER GROUP, LLC
1 - RETAINER
2 - GASKET
3 - BOLT
  1. Disconnect the battery negative cables.
  2. Remove the oil pan drain plug and drain the engine oil. Re-install plug and tighten to 50 N.m (37 ft. lbs.).
  3. Remove transmission and transfer case (if equipped) from vehicle.
  4. Remove flywheel or torque converter drive plate.
  5. Remove flywheel adapter plate.
  6. Disconnect starter cables from starter motor.
  7. Remove starter motor and transmission adapter plate assembly. Refer to STARTER, REMOVAL .
  8. Remove four oil pan rear bolts. Slide a feeler gauge between the seal retainer and oil pan gasket to break the seal.
  9. Remove the six retainer-to-block bolts (3).
  10. Remove the rear seal retainer, and gasket (2).
  11. Support the seal retainer and drive out the crankshaft seal with a hammer and suitable punch.
scientia non olet · About LEMON Manuals