LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (5.7L Engine (Service Information)) >> Engine Block >> FLEXPLATE >> Installation >> Installation

Engine Block: FLEXPLATE: Installation: Installation

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Flexplate Retaining Bolt Removal & Tightening Sequence
GC0088080Courtesy of CHRYSLER GROUP, LLC
  1. Position the flexplate onto the crankshaft and install the retaining bolts hand tight.
  2. Using the sequence shown in illustration, tighten the flexplate retaining bolts to 95 N.m (70 ft. lbs.).
  3. Install the transmission. Refer to appropriate Transmission and Transfer Case articles.
scientia non olet · About LEMON Manuals