Diagnostic Test

WARNING: This page is about a different car, the 2016 RAM 3500 HD and 2016 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

ACTIVE DTC
1. Ignition on, engine not running.
2. With the scan tool, read DTCs.
  NOTE:
  If there any Intake Manifold Temperature Sensor or Coolant Temperature Sensor DTCs present, perform the Diagnostics for those DTCs before continuing with this one.
  
  NOTE:
  If DTCs P2044, P2045, or U02A2 are present, perform the Diagnostics for those DTCs before continuing with this one.
  
  Is this DTC active?
  
  Yes
  - Go To 2
  No
  - Perform the INTERMITTENT CONDITION - DIESEL diagnostic procedure. Refer to INTERMITTENT CONDITION - 6.7L .
DEF QUALITY SENSOR
1. Turn ignition off.
2. Disconnect the DEF Quality Sensor harness connector.
  NOTE:
  Check connectors for corrosion or foreign materials- Clean/repair as necessary.
  
  Are there dirty or damaged pins?
  
  Yes
  - Repair/Replace as necessary.
  - Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to POWERTRAIN VERIFICATION TEST - 6.7L .
  No
  - Replace the DEF Quality Sensor in accordance with the Service Information.
  - Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to POWERTRAIN VERIFICATION TEST - 6.7L .