Sensor, Exhaust Pressure: Installation: Installation

WARNING: This page is about a different car, the 2016 RAM 3500 HD and 2016 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Outside Bracket Mounting Bolt

Courtesy of CHRYSLER GROUP, LLC

If removed, ensure the exhaust pressure sensor tube (1) is clean and not plugged.
If removed, install the exhaust pressure sensor tube (1).
- Tighten fitting (3) to 18 N.m (159 in. lbs.).
- Tighten bolt (2) to 20 N.m (177 in. lbs.).
Fig 2: O-Ring Seal
Courtesy of CHRYSLER GROUP, LLC
If necessary, replace the O-ring seal (1).

Fig 3: Exhaust Pressure Sensor
Courtesy of CHRYSLER GROUP, LLC
Install the exhaust pressure sensor (1). Tighten sensor to 32 N.m (24 ft. lbs.).

Fig 4: Exhaust Pressure Sensor Wire Harness Connector
Courtesy of CHRYSLER GROUP, LLC
Connect the exhaust pressure sensor wire harness connector (1).

Fig 5: Engine Cover, Bolts & Oil Dipstick
Courtesy of CHRYSLER GROUP, LLC
Install the engine cover (3). Tighten bolts (1) to 10 N.m (89 in. lbs.).
Install the oil dipstick (2).
Connect both negative battery cable.