Sensor, Differential Pressure: Installation: Installation

WARNING: This page is about a different car, the 2016 RAM 3500 HD and 2016 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Differential Pressure Tubing, Fittings & Bolts

Courtesy of CHRYSLER GROUP, LLC

If removed, install the differential pressure tubing. Tighten the fittings (1, 6) to 30 N.m (22 ft. lbs.).
If removed, install the differential pressure tubing and tighten the bolts (2, 5) to 5 N.m (44 in. lbs.).

Fig 2: Differential Pressure Sensor, Wire Harness Connector, High Pressure Tubes & Nuts
Courtesy of CHRYSLER GROUP, LLC
Install the Differential Pressure Sensor (DPS) (3). Tighten the nuts (1) to 5 N.m (44 in. lbs.).
Connect the DPS hose (4).
Connect the DPS wire harness connector (2).
Remove support and lower the vehicle.
Connect both of the negative battery cables.