LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1288 (As69RC Automatic Transmission (Service Information) 3500 Hd) >> Diagnosis And Testing >> Hydraulic Pressure Test >> Possible Causes

Possible Causes

WARNING: This page is about a different car, the 2016 RAM 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

If the measured values do not conform to the standard values, locate the possible cause by referring to the following table and inspect the component.

TEST RESULT  CONCEIVABLE CAUSE 
Measured value is higher than standard value in all ranges. Regulator valve is sticking.
 
Measured value is lower than standard value in all ranges. Regulator valve is sticking.
Oil pump is worn or clogged filter.
Measured value is lower than standard value in D range only. Oil leak exists in D range system.
K1 clutch is abnormal, B2 clutch is abnormal.
Measured value is lower than standard value in R range only. K3 clutch is abnormal.
B2 clutch is abnormal, oil leak exists in R range system.