LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 125 (Lamps/Lighting - Exterior (Service Information)) >> Switch, Parking Brake >> Diagnosis And Testing >> Diagnosis And Testing - Park Brake Switch >> Indicator Illuminates During Bulb Test, But Does Not When Park Brake Applied

Indicator Illuminates During Bulb Test, But Does Not When Park Brake Applied

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the battery negative cable. Disconnect the body wire harness connector for the park brake switch from the switch terminal. Apply the parking brake. Check for continuity between the park brake switch terminal and a good ground. There should be continuity. If OK, refer to  2. If not OK, replace the ineffective park brake switch.
  2. Disconnect the instrument panel wire harness connector (Connector C2) for the instrument cluster from the cluster connector receptacle. Check for continuity between the park brake switch sense circuit cavities of the body wire harness connector for the park brake switch and the instrument panel wire harness connector for the instrument cluster. There should be continuity. If not OK, repair the open park brake switch sense circuit between the park brake switch and the instrument cluster as required.
scientia non olet · About LEMON Manuals