Booster, Power Brake: Removal: Removal
WARNING: This page is about a different car, the 2016 RAM 3500 HD and 2016 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - MOUNTING NUT |
| 2 - POWER BRAKE BOOSTER |
- Remove the master cylinder. Refer to MASTER CYLINDER, BRAKE, REMOVAL .
- Disconnect the vacuum line at the booster.
- Remove the clip securing the booster push rod to the brake pedal.
- Remove the brake lamp switch. Refer to SWITCH, BRAKE FLUID LEVEL, REMOVAL .NOTE:
Do not discard the stop lamp switch as it can be adjusted and reinstalled.
- Remove the nuts (1) from the booster mounting studs.
- Remove the booster (2) and gasket from front cowl panel.