6.7L Diesel

WARNING: This page is about a different car, the 2016 RAM 3500 HD and 2016 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Camshaft Position Sensor & O-Ring

Courtesy of CHRYSLER GROUP, LLC

Lubricate the O-ring seal (2) with clean engine oil.

Fig 2: Camshaft Position Sensor & Bolt
Courtesy of CHRYSLER GROUP, LLC
Install the Camshaft Position (CMP) sensor (2) and tighten the bolt (1) to 12 N.m (9 ft. lbs.).

Fig 3: Camshaft Position Sensor Wire Harness Connector
Courtesy of CHRYSLER GROUP, LLC
Connect the CMP sensor wire harness connector (1).
Install the left front wheelhouse splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, INSTALLATION .
Connect both of the negative battery cables.