Bumper, Rear: Installation: Installation

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Bumper, Trailer Hitch & Bolts

Courtesy of CHRYSLER GROUP, LLC

Position the bumper (1) onto the vehicle and line up the pins on the sides.
Install the bolts (3 and 4).
Tighten the bolts (3) to 54 Nm (40 lbf-ft).
Tighten the bolts (4) to 54 Nm (40 lbf-ft).

Fig 2: Rear Bumper Electrical Connectors
Courtesy of CHRYSLER GROUP, LLC
Connect the electrical connectors (2).