LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1154 (BW44-45 Transfer Case (Service Information) 1500) >> Motor, Shift >> Installation >> Installation

Motor, Shift: Installation: Installation

WARNING: This page is about a different car, the 2016 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the mounting surface of any sealer.
  2. Apply a thin bead of Mopar® ATF RTV to the mounting surface.
    NOTE:

    Verify that the shift motor position and sector shaft orientation are aligned. It may be necessary to manually shift the transfer case if the shift motor and sector shaft are not aligned.

  3. Install the shift motor onto the transfer case.
  4. Install the shift motor and mode sensor assembly onto the transfer case.
  5. Install the bolts to hold the shift motor and mode sensor assembly onto the transfer case. Tighten the bolts to 8-11 N.m (72 - 96 in. lbs.).
  6. While holding the shift motor bracket tight against the shift motor, tighten the bracket to the transfer case to 8-11 N.m (72 - 96 in. lbs.).
  7. Tighten the shift motor bracket to the shift motor to 2.8 - 4 N.m (24 - 36 in. lbs.).
  8. Connect the shift motor and mode sensor wiring.
  9. Refill the transfer case as necessary with the correct fluid for the application. Refer to CAPACITIES AND RECOMMENDED FLUIDS, SPECIFICATIONS .
  10. Lower the vehicle and verify proper transfer case operation.
scientia non olet · About LEMON Manuals