With Injected Ring

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Positioning U-Joint Press With Receiver On Propeller Shaft Yoke

Courtesy of CHRYSLER GROUP, LLC

Place shaft yoke in vise.
Position U-joint press (1) with receiver (2) on propeller shaft yoke.

Fig 2: Pressing U-Joint Bearing Caps Out Of Shaft Yoke
Courtesy of CHRYSLER GROUP, LLC
Pressed U-joint bearing caps (1) out of shaft yoke (2).
Remove lower bearing cap from shaft yoke.

Fig 3: Pressing U-Joint Bearing Cap
Courtesy of CHRYSLER GROUP, LLC
Turn shaft over and position press (1) with receiver (2) on shaft yoke.
Press remaining U-joint bearing cap out of shaft yoke.

Fig 4: Removing Flange
Courtesy of CHRYSLER GROUP, LLC
Remove flange (1) with U-joint out of shaft yoke (2).

Fig 5: U-Joint Press With Receiver
Courtesy of CHRYSLER GROUP, LLC
Position U-joint press (2) with receiver (1) on flange.

Fig 6: Pressing U-Joint Bearing Caps Out Of Flange
Courtesy of CHRYSLER GROUP, LLC
Press U-joint bearing caps (1) out of flange (2).
Remove bearing cap on the outside of the flange.

Fig 7: Pressing Remaining U-Joint Bearing Cap Out Of Flange
Courtesy of CHRYSLER GROUP, LLC
Position U-joint press (2) with receiver (1) on flange.
Press remaining U-joint bearing cap out of flange.
Remove U-joint from flange.