Torque Specifications
WARNING: This page is about a different car, the 2016 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
AXLE
| DESCRIPTION | SPECIFICATION |
|---|---|
| Axle Ratio | 3.21, 3.55, 3.92, 4.10 |
| Pinion Flange Runout | 0.050 mm (0.002 in.) |
| Ring Gear Diameter | 235 mm (9.25 in.) |
| Ring Gear Backlash | 0.12 - 0.20 mm (0.005 - 0.008 in.) |
| Pinion Torque To Rotate - New Bearings | 1.9 - 2.5 N.m (17 - 22 in. lbs.) |
| Fill Level - From Bottom of Fill Hole | 3 mm (1/8 in.) ± 3 mm (1/8 in.) |
TORQUE SPECIFICATIONS
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. | COMMENT |
|---|---|---|---|---|
| Drain and Fill Plugs | 70 | 52 | - | |
| Differential Cover Bolts | 44 | 32 | - | |
| Bearing Cap Bolts | 136 | 100 | - | Do not reuse these fasteners. If removed, a NEW fastener must be installed and tightened to specifications. |
| Ring Gear Bolts | 225 | 166 | - | |
| Pinion Nut Minimum | 285 | 210 | - | Do not reuse these fasteners. If removed, a NEW fastener must be installed and tightened to specifications. |
| Adjuster Lock Screw | 11 | - | 97 | |
| Backing Plate Bolts | 102 | 75 | - | |
| Pinion Mate Shaft Lock Screw | 26 | 19 | - | Do not reuse these fasteners. If removed, a NEW fastener must be installed and tightened to specifications. |