LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1127 (Tires & Wheels (Service Information) 1500) >> Wheels >> Stud, Wheel >> Installation >> Rear

Stud, Wheel: Installation: Rear

WARNING: This page is about a different car, the 2016 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Installing Rear Wheel Stud
GC0082305Courtesy of CHRYSLER GROUP, LLC
CAUTION:

Move axle shaft carefully to prevent damage to the shaft bearing and seal in the axle tube.

  1. Install the new stud (4) into the back of the hub flange (2) and seat as follows:
    1. Install three proper sized washers (1) onto the new stud (4), then install a lug nut (3) with the flat side of the nut against the washers.
    2. Tighten the lug nut (3) until the stud (4) is pulled into the hub flange (2). Verify that the stud is properly seated into the flange.
    3. Remove the lug nut (3) and washers (1).
  2. Install the axle shaft. Refer to SHAFT, AXLE, INSTALLATION .
  3. Using a new lug nut  on the new studs that were installed, install the wheel and tire assembly. Refer to INSTALLATION .
  4. Remove the supports and lower the vehicle.
scientia non olet · About LEMON Manuals