LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1127 (Tires & Wheels (Service Information) 1500) >> Installation >> Tire And Wheel Assembly

Tire And Wheel Assembly

WARNING: This page is about a different car, the 2016 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Installing wheels without good metal-to-metal contact with the mounting surface could cause loosening of the wheel mounting (lug) nuts. This could adversely affect the safety and handling of the vehicle.

NOTE:

Never use oil or grease on studs or wheel mounting (lug) nuts.

NOTE:

Clean wheel mounting surfaces, removing any build-up of corrosion. It is important to have good metal-to-metal contact between wheel and vehicle.

  1. Install the tire and wheel assembly on the hub and lightly snug all five wheel mounting (lug) nuts. Do not tighten at this time. 
  2. Progressively tighten wheel mounting (lug) nuts, in a star pattern, to the proper specification. Refer to SPECIFICATIONS .
  3. If applicable, install wheel center cap.
  4. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals