LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1117 (Steering System - 1500) >> Column >> Lever, Gearshift >> Installation >> Lever Only

Lever Only

WARNING: This page is about a different car, the 2016 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Gearshift Lever Assembly Components
GC0088327Courtesy of CHRYSLER GROUP, LLC
  1. Install the gearshift lever (1) in the gearshift lever assembly (2).
  2. Install the gearshift lever pinch bolt (7) and tighten to the proper SPECIFICATIONS .
  3. Connect the gearshift harness retainers (6).
  4. Connect the gearshift harness connector (5).
  5. Install the upper and lower column shrouds, steering column opening cover, and reinforcement. Refer to SHROUD, STEERING COLUMN, INSTALLATION .
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals