LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1113 (Base Brakes (Service Information) 1500) >> Hydraulic/Mechanical >> Tubes And Hoses, Brake >> Installation >> Rear Brake Hose - 1500 Series

Rear Brake Hose - 1500 Series

WARNING: This page is about a different car, the 2016 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Brake Hose, Routing Clips, Flare Nut & Banjo Bolt
GC0173527Courtesy of CHRYSLER GROUP, LLC
  1. Position the brake line. Install the brake hose retainer clip bolt (1) located at the frame and tighten to 20 N.m (15 ft. lbs.).
  2. Install the banjo bolt (4) at the caliper using two new washers and tighten to 28 N.m (21 ft. lbs.).
    Fig 2: Rear Brake Hose, Routing Clips, Flare Nut & Banjo Bolt
    GC0173527Courtesy of CHRYSLER GROUP, LLC
  3. Connect the antilock sensor harness to the routing clips (5).
  4. Remove the supports and lower the vehicle.
  5. Remove the prop rod from the brake pedal.
  6. Bleed the area of repair for the brake system.If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be performed.  . Refer to STANDARD PROCEDURE  .
scientia non olet · About LEMON Manuals