Front Brake Hose
WARNING: This page is about a different car, the 2016 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - MOUNTING BOLT |
| 2 - BRAKE HOSE |
| 3 - BRAKE HOSE BANJO BOLT |
- Position the brake hose (2) and install the mounting bolt (1) at the frame.
- Install the brake hose banjo bolt (3) at the caliper.
- Secure the wheel speed sensor harness in the retaining clips of the brake hose.
- Remove the support and lower the vehicle.
- Remove the prop rod from the brake pedal.
- Bleed the area of repair for the brake system, If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be performed. . Refer to STANDARD PROCEDURE .