LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1113 (Base Brakes (Service Information) 1500) >> Hydraulic/Mechanical >> Adapter, Disc Brake Caliper >> Removal >> Rear

Adapter, Disc Brake Caliper: Removal: Rear

WARNING: This page is about a different car, the 2016 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Remove the wheel and tire assembly.
  3. Drain a small amount of fluid from master cylinder brake reservoir with a clean  suction gun.
  4. Bottom the caliper pistons into the caliper by prying the caliper over.
  5. Remove the caliper slide bolts.
  6. Remove the disc brake caliper from the mount.
    Fig 1: Brake Pads, Anti-Rattle Clips & Caliper Adapter Mounting Bolts
    GC0173502Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    Never allow the disc brake caliper to hang from the brake hose. Damage to the brake hose will result. Provide a suitable support to hang the caliper securely.

  7. Remove the inboard (3) and outboard brake pads (4).
  8. Remove the anti-rattle clips (5).
  9. Remove and discard the caliper adapter mounting bolts (2).
  10. Remove the caliper adapter (1).
scientia non olet · About LEMON Manuals