LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1108 (Fuel System - 1500) >> Fuel Injection, Diesel >> Sensor, Crankshaft Position >> Installation >> Installation

Sensor, Crankshaft Position: Installation: Installation

WARNING: This page is about a different car, the 2016 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Crankshaft Position Sensor & Bolt
GC0146603Courtesy of CHRYSLER GROUP, LLC
  1. Clean the area and bore around Crankshaft Position Sensor (CKP).
  2. Install the CKP sensor (2). Tighten the bolt (1) to 6 N.m (53 in. lbs.).
    Fig 2: Crankshaft Position Sensor Wiring Harness Bracket & Bolts
    GC0146606Courtesy of CHRYSLER GROUP, LLC
  3. Install the bolts (1) attaching the wire harness connector bracket (2) to oil pan and tighten to 8 N.m (71 in. lbs.).
    Fig 3: Crankshaft Position Sensor Connector
    GC0146607Courtesy of CHRYSLER GROUP, LLC
  4. Connect the CKP sensor harness connector (1).
  5. Install the flex plate. Refer to FLEXPLATE, INSTALLATION .
  6. Connect the negative battery cable.
scientia non olet · About LEMON Manuals