LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1107 (Ignition System (Service Information) 1500) >> Sensor, Camshaft Position >> Removal >> 3.0L Diesel

3.0L Diesel

WARNING: This page is about a different car, the 2016 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Camshaft Position Sensor, Connector & Bolt
GC0146584Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Disconnect the Camshaft Position (CMP) sensor wire harness connector (3).
  3. Remove the bolt (1) and the CMP sensor (2).
scientia non olet · About LEMON Manuals