LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1103 (3.0L Diesel (Service Information) 1500) >> Engine Mounting >> Insulator, Engine Mount, Right >> Removal >> 4X4 - Right

4X4 - Right

WARNING: This page is about a different car, the 2016 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable.
    Fig 1: Removing/Installing Engine Cover
    GC0158138Courtesy of CHRYSLER GROUP, LLC
  2. Remove the engine cover (1).
  3. Remove the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL .
  4. Remove the serpentine belt. Refer to BELT, SERPENTINE, REMOVAL .
    Fig 2: CAC Hose & EGR Air Flow Control Valve
    GC0158047Courtesy of CHRYSLER GROUP, LLC
  5. Disconnect the CAC hose (1) from the EGR air flow control valve (2).
    Fig 3: Engine Lifting Special Tool VM.10360A-3 & Bolts
    GC0157996Courtesy of CHRYSLER GROUP, LLC
  6. Install the (special tool #VM.10360A-3, Bracket, Engine Lifting (Left Front)) (1) and securely tighten bolts (2).
  7. Assemble the Driveline Support Fixture (special tool #8534B, Fixture, Driveline Support) and support the engine.
  8. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  9. If equipped, removed the belly pan.
  10. Remove the front driveline axle. Refer to REMOVAL .
    Fig 4: Left Engine Mount Bracket & Bolts
    GC0158063Courtesy of CHRYSLER GROUP, LLC
  11. For right side, remove the bolts (5), damper (7), bracket (6) the left engine mount (1).
    Fig 5: Right Engine Mount Bracket & Bolts
    GC0158090Courtesy of CHRYSLER GROUP, LLC
  12. If necessary, remove the bolts (2) and the right engine mount bracket (1).
scientia non olet · About LEMON Manuals